Diebold Nixdorf ATM Parts Installation Guide

1. Power Off Completely Shut down the ATM main power, unplug the power cord, and wait at least 30 seconds for internal capacitors to discharge.
2. Anti-static Protection Use an anti-static wristband or touch grounded metal before handling circuit boards to prevent ESD damage.
3. Record Connections Take photos of cable positions before disconnecting to ensure correct reinstallation.
4. Tools Required Torx screwdrivers, hex keys, cable ties, and clean lint-free cloth.

(01750302835 / 01750302898)

1. Open the front fascia and release the green latch to pull out the printer module tray.
2. Disconnect power and data cables from the old printer.
3. Remove mounting screws and take out the faulty unit.
4. Install the new printer, secure with screws, and reconnect cables as labeled.
5. Push the tray back until it locks into place.
6. Power on and print a self-test page to verify operation.

(01750299985 / 1750299985)

1. Open the rear or side cover of the ATM.
2. Disconnect all DC output cables and AC input connector from the old power supply.
3. Remove mounting screws and replace with the new PSU.
4. Reconnect cables following the original routing.
5. Close the cover, power on, and check for error codes or abnormal noise.

(01750287366 / 1750287366)

1. Open the safe door and pull out the RM4 cash module.
2. Disconnect ribbon cables and power connectors from the control board.
3. Unscrew and remove the old PCB.
4. Install the new control board and fasten screws.
5. Reconnect all cables in their original order.
6. Slide the module back and lock it, then test dispenser functions.

(01750291701 / 1750291697 etc.)

1. Release the module using the green mechanical lock.
2. Disconnect related sensors, motors, and cables.
3. Replace the assembly or sub-component.
4. Reattach cables and secure the module.
5. Run a diagnostic test to ensure smooth movement.

• Power on without error codes or warning lights.
• Run self-diagnostics via the ATM operator menu.
• Test printing, cash dispensing, and card reading functions.
• Ensure all cables are secured and not pinched by moving parts.
• Confirm all doors, latches, and locks are fully closed.

• Always use matching part numbers to avoid compatibility issues.
• Do not force connectors or components during installation.
• Keep the interior clean and free of dust or paper debris.
• If persistent errors occur, recheck cable connections and part compatibility.